I know all the steps and have seen all the warnings (ex. I guess I have an excuse to play with stock PICs instead of Picaxe now. I play with Picaxe and I used to hack Z-80 back in the day, but this is my first attempt at programming a PIC Microcontroller. We LOVE our Catgenie and I would hate to brick the processor board because I did something stupid. Now that I have my PIC version I can get my software and the PicKit all ready to go for tomorrow. Now I can just plug in and program! I am doing this on my porch because that is where I have the room and the best light but the sun is going down now so I am done with hardware for today. I used a tiny drillbit in a pin-vice and checked for continuity to the solder pads. I lucked out in that all they did to the header was run a soldering iron over pin 3. I had to remove the board to see what kind of defeat the factory used for my programming header anyway so I was able to see (through a big illuminated magnifier) the pic was a PIC16F1939. Has been most reliable, albeit most inconvenient, to power it from the Hurt to do so) My experiences with the cat genie have been mixed, but it (does not need both, though it should not If you receive a "wrong code"Įrror, then select the other device and re-connect.Īs said before, the device needs to be powered, either from the PIKKIT orįrom the on-board power supply. What I would suggest is that you load up an empty IDE session and selectįirst one device and then try to connect. The reality is that when you get the wrong code, then there is something Where you can look up the device based on the ID code.) (Researching just now seems to confirm that there is no central place What devices use which device codes and found a fair amount of confusion. When I was getting the wrong device code, I spent some time researching "device" is attached, but in honesty I have not looked hard. I've never seen in the IDE (or other tools) a way to actually query what I have mostly used IDE-8 but am starting to transition to IDE-X. I do a fair amount of work with different PIC's on a variety of projects.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |